45
Choose Advanced Setup > Routing > Policy Routing and the following page appears.
In this page, you can add or remove a static policy rule.
Click the Add button to display the following page.
In this page, enter the policy name, source IP and default gateway, and select the physical LAN port and interface. After
finishing setting, click Apply/Save to save and apply the settings.
Choose Advanced Setup > Routing > RIP and the following page appears.
In this page, if you want to configure an individual interface, select the desired RIP version and operation, and then select
the Enabled checkbox for the interface.
After finishing setting, click Apply/Save to save and apply the settings.
To Next Page
Loading...
