NIRStar 14.1 - User Manual
Page 69 of 124
TrigOuts=0 No. of trigger outputs (only available for NIRScoutX)
AnIns=0 No. of auxiliary analog inputs (future option)
SamplingRate=3.906250 Sampling rate in Hz
Mod Amp="0.40 0.40" Modulation amplitude used for illumination
Threshold=”0.00 0.00” Modulation threshold used (≠0 only for Laser)
Paradigm Information
Records details about the experimental paradigm.
[Paradigm]
StimulusType=None Specifies paradigm (future option)
Experimental Notes
Notes entered into the notes editor of the user interface (see Section 9) are saved here.
[ExperimentNotes]
Notes="[Type notes here]"
Gain Settings
The gain settings used in the measurement are recorded in a table. The gain for channel S
i
-D
j
is found in
the i
th
row and j
th
column (counting from the upper left).
Valid gains for neighboring source-detector-pairs usually are in the range of 4...7 for adults, depending
on head size, hair density/color, and measurement site. A gain value of ‘8’ indicates that too little or no
light was received for this particular pairing (see also, section 8.2).
[GainSettings]
Gains=#
5 8 5 5 8 8 8 8 8 8 8 8 8 8 8 8
4 4 5 8 8 8 8 8 8 8 8 8 8 8 8 8
8 8 6 6 6 6 8 8 8 8 8 8 8 8 8 8
8 8 8 5 8 6 5 8 8 8 8 8 8 8 8 8
8 5 5 8 6 8 8 8 8 8 8 8 8 8 8 8
8 8 8 8 8 6 5 5 8 8 8 8 8 8 8 8
8 8 8 8 6 6 8 6 8 8 8 8 8 8 8 8
8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8
8 8 8 8 8 8 8 8 8 5 6 8 5 8 8 8
8 8 8 8 8 8 8 8 4 4 5 8 8 8 8 8
8 8 8 8 8 8 8 8 8 8 6 6 6 6 8 8
8 8 8 8 8 8 8 8 8 8 8 8 6 6 8 6
8 8 8 8 8 8 8 8 5 8 5 6 8 8 8 8
8 8 8 8 8 8 8 8 8 8 8 8 8 6 5 5
8 8 8 8 8 8 8 8 8 8 8 5 8 6 6 8
8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8
#
The gain values range from 0 (gain factor 10
0
= 1) through 8 (gain factor 10
8
). The hash symbols '#' are
used to identify the beginning and end of the table.
To Next Page
Loading...
