Revision 3
b.
Inspect drive belt, tensioner bearing and fan hub. Refer
to
MANUFACTURERS'
LITERATURE included with this manual.
Water Jetting
Unit Bolts and Screws
a.
Make sure that all bolts and screws are tight.
b.
Remove V-belt guard. Check
to
see that shafts are parallel and that sheaves are in
proper alignment.
7.
Every Two
(2)
Years or Approximately Every 2000 Hours of
Operation
Diesel Engine
a.
Flush coolant system. Refer
to
MANUFACTURERS' LITERATURE section for
information.
b.
Inspect vibration dampener for alignment. Refer
to
MANUFACTURERS' LITERATURE
section for information.
c.
Inspect air compressor for carbon build up. Refer
to
MANUFACTURERS'
LITERATURE for instructions.
Ill. Suggested Component Cleaning Schedule
The following are suggested cleaning instructions for components utilized in high pressure
water jetting units designed and manufactured by the NLB Corporation.
Clean each component at the suggested service interval.
If
any special cleaning instructions
for vendor components on the unit need
to
be addressed, the manufacturer's
recommendations must be followed by referring
to
the MANUFACTURERS' LITERATURE
section in this manual.
Wipe exterior surfaces
of
equipment to remove dust, oil, and other foreign deposits. Unless
otherwise noted
in
the "REMARKS" column below, wash components with hot soapy water
and rinse thoroughly with clean water.
Use solvent
to
remove hardened deposits. Carefully
remove dust and debris from interior parts by wiping or blowing
as
required. Do not use
paper towels. Do not create air-borne dust.
© Copyright August, 2000 NLB Corporation
5-1
5
To Next Page
Loading...