Revision 3
If
the lubricator reservoir should be allowed to run dry, refer to Section
8:
REPAIR -
L-55i
Oil Plunger Lubricator - Pump Priming.
LUBRICANT TYPE QUANTITY REQUIRED SERVICE INTERVAL
SAE 15W40
Four ( 4) qts. (3.8 l) Automatic, adjustable.
Optional reservoir with low
10-12
drops per minute
level shutdown:
20.0 qts.
(18.9
l)
Note:
Handling and disposal
of
used lubricating oil
may
be subjected
to
international,
federal, state, and local law regulation. Use authorized waste disposal facilities,
including civic amenity sites and garages providing authorized facilities for receipt
of
used lubricating
oil.
If
in
doubt, contact the Environmental Protection Agency
or
appropriate agency
in
your area for details on laws
and
services.
Estimated L-55i Oil Plunger Lubricator Reservoir Refill Intervals
The standard lubricator reservoir holds four ( 4) qts. (3.8 l)
Based on 10 drops per minute: 48 hours
Based on 20 drops per minute: 24 hours
Based on
30 drops per minute: 16 hours
Estimated L-55i Oil Plunger Lubricator Reservoir Refill Intervals
The optional lubricator reservoir holds 20.0 qts. (18.91)
Based on 10 drops per minute: 240 hours
Based on 20 drops per minute: 120 hours
Based on
30 drops per minute: 80 hours
Water Plunger
Lubricator
- Optional
The cartridge flanges on your NLB high pressure water jetting unit have been provided with
fittings which deposit water directly onto the plungers as the high pressure pump runs.
Packing and plunger lives are greatly extended by this lubrication. The lubricator was
factory adjusted for 1/3 gallon (
1.2
l)
of
water per plunger per minute. Flow is constant but
pressure is limited to the plant inlet water supply pressure.
© Copyright August, 2000 NLB Corporation
5-20
To Next Page
Loading...