7210 SAS-D CHASSIS INSTALLATION GUIDE Configuring the System
Issue: 08 3HE 10087 AAAA TQZZA Edition 01 61
Press ENTER, or type 'none' for no Config URL.
Config File URL:
If you are not booting for the first time, enter the location of the configuration file.
Otherwise, type none.
Boot Interface Management
-------------------------
You specified a network location for either the
software or the configuration file. You need to
configure either uplinkA or uplinkB ports.
You will be asked to configure the port number, IP address,
static routes, and VLAN Id for uplink ports.
uplinkA Port Setting
--------------------
Existing uplinkA port settings are:
uplinkA-port 1/1/1
uplinkA-address 0
uplinkA-vlan 0
uplinkA port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
Type edit.
Existing uplinkA port for Boot Interface Management is port 1/1/1.
Press ENTER to keep it.
Enter the new uplinkA port number for Boot Interface Management:
Enter the port which it connected to the network (for example, 1/1/10).
You need to assign an IP address for this port.
The IP address should be entered in standard
dotted decimal form with a network length.
example: 192.168.1.169/10
Or type "0" to obtain IP address and static route
through DHCP. Existing IP address and static routes
will be deleted.
uplinkA port is configured to obtain IP address and static route through dhcp.
Press ENTER to keep it.
Enter uplinkA port IP Address:
Enter the IP address and the mask that the device should use (for example,
10.135.4.172/10).
Since the FTP server is on a different subnet, enter the IP routing information:
You specified network locations which might require
static routes to reach. You will be asked to
enter static routes until all the locations become
To Next Page
Loading...
