Configuring the System
62
7210 SAS-D CHASSIS INSTALLATION GUIDE
3HE 10087 AAAA TQZZA Edition 01 Issue: 08
reachable.
Static routes should be entered in the following format:
prefix/mask next-hop ip-address
example: 192.168.0.0/16 next-hop 192.168.1.254
Would you like to add a static route? (yes/no)
Type yes and press Enter.
Enter route:
Enter a static route to the FTP server’s subnet (for example, 10.10.170.0/10
next-hop 10.135.4.1) at the prompt.
You need to configure the VLAN Id for this port
VLAN Id can be between 0 to 4094. To send out
packets with out any VLAN tags, type "null".
Existing VLAN Id for uplinkA port is VLAN Id 0.
Press ENTER to keep it.
Enter the new VLAN Id for uplinkA port:
Press Enter if you want to send out untagged packets. Otherwise, enter the VLAN
tag.
uplinkB Port Setting
--------------------
uplinkB port is disabled for Boot Interface Management,
Press ENTER to proceed with no uplinkB port settings
Or "enable" to enable the port for Boot Interface Management:
Enter disable since we do not want the backup link.
Press Enter.
New Settings
------------
primary-image ftp://*:*@10.10.170.22/./images/both.tim
primary-config cf1:\config.txt
#uplinkA Port Settings:
uplinkA-port 1/1/10
uplinkA-address 10.135.4.172/10
uplinkA-vlan 0
uplinkA-route 10.10.170.0/10 next-hop 10.135.4.1
#System Settings:
wait 3
persist off
console-speed 115200
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no):
Type yes and press Enter. The 7210 SAS-D should boot now.
Primary image location: ftp://*:*@10.10.170.22/./images/both.tim
To Next Page
Loading...
