Nokia 8210 - Reference Information; Access Codes

AT Command Set for Nokia 8210 70
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CMT New SMS-DELIVER
text mode:
+CMT: <oa>,[<alpha>],<scts> [,<tooa>,<fo>,<pid>,<dcs>,<sca>,
<tosca>,<length>]<CR><LF><data>
PDU mode:
+CMT: [<alpha>],<length> <CR><LF><pdu>
- when +CNMI=0:
routed messages are buffered into TA/ME (if buffer is full, 'memory capacity
exceeded' should be sent to network)
- when +CNMI=1:
in on-line data state routed messages are rejected (e.g. 'memory capacity exceeded'
is sent to network and when command mode is entered 'memory available' is sent to
network); in command mode forwarded directly to TE
- when +CNMI=2:
in on-line data state routed messages are buffered into TA/ME (if buffer is full,
'memory capacity exceeded' should be sent to network and when command mode is
entered 'memory available' should be sent to network); in command mode forwarded
directly to TE
- when +CNMI=3:
behaves like +CNMI=2 case (V.80 does not support this long result codes).
<alpha> not supported by NMP products. See also command +CNMI, page 27.
(GSM 07.05 section 3.4.1).
+CMTI New SMS-DELIVER Indication
+CMTI: <mem>,<index>
- when +CNMI=0:
indications are buffered into TA/ME
- when +CNMI=1:
in on-line data state indications are discarded; in command mode forwarded directly
to TE
- when +CNMI=2:
in on-line data state indications are buffered into TA/ME; in command mode
forwarded directly to TE
- when +CNMI=3 and V.80 in-band mode enabled:
forwarded directly to TE
- when +CNMI=3 and V.80 in-band mode is disabled or not supported:
behaves like +CNMI=2 case
See also command +CNMI, page 27.
In the case of the Card Phone: Class 0 and message waiting indication group
(discard) SMs shall cause this result code when +CNMI <mt> equals 1 or 3. (GSM
07.05 section 3.4.1).