2-6 Communicator interface
When the search field appears at the bottom of
the display, you can search for items by entering
text into the search field with the keyboard.
After the correct item has been selected, press
the command button corresponding to the com-
mand you wish to apply to the item, for example,
Open
.
Note:
Most applications have
Settings
as one of
the main view commands. The values of these
settings will be used as defaults for that applica-
tion. Options chosen elsewhere affect only the
document, card or item which is active or being
sent. The following figures illustrate certain
communicator interface conventions:
1. When a command appears dimmed, the com-
mand cannot be used (see the figure below).
2. When a value appears on a dotted line with a
cursor, enter a new value manually via the key-
board.
3. A pop-up box. Choose an item and press
OK
or
Cancel
(see the figure below).
When a setting with next to it is selected,
pressing
Change
toggles the value or opens a
pop-up box. See the figure above. When a setting
with next to it is selected, pressing
Change
opens a new settings view. When you press a
command with next to its name, as in
Logs
in figure 2-10, only the command set changes.
getting.frm Page 6 Thursday, January 16, 1997 4:09 PM
To Next Page
Loading...
