Nokia ONT - Figure 8-16 WAN Page - Route Mode; Table 8-13 WAN Parameters - Route Mode

Configure
a
G
-
2426G
-
B
indoor
ONT
Network configuration
Configuring WAN
Nokia
ONT
3FE-49441-ABAA-TCZZA
June
2021
Issue 1
123
Figure 8-16 WAN page - Route Mode
2
Configure the following parameters for a specific WAN connection.
Table 8-13, “WAN parameters - Route mode” (p. 123) describes the fields in the WAN network
window for Route Mode
Table 8-13 WAN parameters - Route mode
Field Description
WAN Connection List Select a WAN connection from the list to set the connection parameters.
Connection Type Select a connection type: IPoE or PPPoE.
Connection mode This option is only available for the operator ID MSNA, and for some operator-specific operator
IDs.
Choose a connection mode: Route Mode or Bridge Mode. The default is Route Mode.
If you select Bridge Mode, see Figure 8-17, “WAN page - Bridge Mode” (p. 124) and Table 8-14,
“WAN network parameters—Bridge Mode” (p. 125)
IP mode Select an IP mode from the list: IPv4 or IPv6.
Enable/Disable Select this checkbox to enable the WAN connection.
NAT Select this checkbox to enable NAT.