Nokia ONT - Safety Information

Install
a
G
-
2426G
-
B
indoor
ONT
Safety information
Nokia
ONT
3FE-49441-ABAA-TCZZA
June
2021
Issue 1
70
• voltmeter or multimeter
• optical power meter
• drill and drill bits
• paper clip
6.6 Safety information
Read the following safety information before installing the unit.
DANGER
Hazard
Hazardous electrical voltages and currents can cause serious physical harm or death. Always use
insulated tools and follow proper safety precautions when connecting or disconnecting power
circuits.
Make sure all sources of power are turned off and have no live voltages present on feed lines or
terminals. Use a voltmeter to measure for voltage before proceeding.
Always contact the local utility company before connecting the enclosure to the utilities.
WARNING
Equipment Damage
This equipment is ESD sensitive. Proper ESD protections should be used when removing the fiber
access cover of the indoor ONT.
CAUTION
Service Disruption
Keep indoor ONTs out of direct sunlight. Prolonged exposure to direct sunlight can damage the unit.
Note: Observe the local and national laws and regulations that may be applicable to this
installation.
Observe the following:
• The indoor ONT should be installed in accordance with the applicable requirements of the
NEC or CEC. Local authorities and practices take precedent when there is conflict between
the local standard and the NEC or CEC.
• The indoor ONT must be installed by qualified service personnel.
• Indoor ONTs must be installed with cables that are suitably rated and listed for indoor use.
• See the detailed specifications in the Chapter 5, “G-2426G-B unit data sheet” for the
temperature ranges of these ONTs.