Nokia ONT - Figure 6-8 G-2426 G-B ONT and UPS

Install
a
G
-
24
26G
-
B
indoor
ONT
Connect a UPS to a G-2426G-B ONT
Nokia
ONT
3FE-49441-ABAA-TCZZA
June
2021
Issue 1
79
6.9.1 Connect a CyberPower DTC36U12V3-G UPS
Use this procedure to connect a UPS to a G-2426G-B indoor ONT.
See Table 5-3, “G-2426G-B UPS ordering information” (p. 47) for the supported power supplies.
Before starting this procedure, ensure that the following items are available:
• Battery for the CyberPower UPS DTC36U12V3-G
• Cable to connect the UPS to the ONT
• Extended battery pack with the battery inside if 24 hours of backup for emergency calls is
needed
• UPS AC power cable
1
Place the indoor ONT unit and the UPS on a flat surface, such as a desk.
2
Plug the cable into the UPS connector on the G-2426G-B ONT and the output connector on the
UPS, as shown in Figure 6-8, “G-2426G-B ONT and UPS” (p. 78). The battery is inside of the
UPS.
Figure 6-8 G-2426G-B ONT and UPS
CyberPower UPS
DTC50U12V3
with a battery
Output
connector
External
battery
3-prong
AC plug
UPS connector
36308
The following figure shows an example ONT and UPS. The position of the connections may differ for each ONT model
The connector for the 6 foot 3EM24378AA cable matches the socket for the 36W UPS
Cyberpower DTC36U12V3-G.