G-2426G-B standards compliance
3FE-49441-ABAA-TCZZA
Issue 1
5.11.1 Energy-related products standby and off modes compliance
Hereby, Nokia declares that the G-2426G-B ONTs are in compliance with the essential
requirements and other relevant provisions of Directive 2009/125/EC together with Commission
Regulation (EC) No 1275/2008 and Commission Regulation (EC) No 801/2013.
The G-2426G-B ONTS qualify as equipment with high network availability (HiNA) functionality.
Since the main purpose of G-2426G-B ONTs is to provide network functionality with HiNA 7 days
/24 hours, the modes Off/Standby, Power Management, and Networked Standby are inappropriate.
For information about the type and number of network ports, see 5.5 “G-2426G-B interfaces and
interface capacity” (p. 54) in this chapter.
For information about power consumption, see 5.7 “G-2426G-B detailed specifications” (p. 61) in
this chapter.
5.11.2 FCC statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
5.11.3 FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment
and it also complies with Part 15 of the FCC RF Rules. This equipment must be installed and
operated in accordance with provided instructions and the antenna(s) used for this transmitter must
be installed to provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter. End-users and installers
must be provided with antenna installation instructions and consider removing the no-collocation
statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause
undesired operation.
To Next Page
Loading...
