Nokia ONT - ONT Considerations and Limitations

G
-
2426G
-
B
unit
data
sheet
G-2426G-B special considerations
Nokia
ONT
3FE-49441-ABAA-TCZZA
June
2021
Issue 1
68
Table 5-17 G-2426G-B ONT considerations and limitations
Considerations and limitations
Call History Data collection (ONTCALLHST) is supported, except for the following parameters: RTP packets (discarded), far-end RTCP
and RTCP-XR participation, RTCP average and peak round trip delay, MOS, average jitter, number of jitter-buffer over-runs and under
runs.
Some voice features are configurable on a per ONT basis, including Call Waiting, Call Hold, 3-Way Calling, and Call Transfer.
The maximum value of the ringing AC voltage is 60Vrms, and the ring DC offset voltage is suggested to be 0V except for NAR variant.
The following voice features / GSIP parameters are configurable on a per-Client/ per-ONT basis (not per-Subscriber):
• Enable Caller ID and Enable Caller Name ID
• Digitmap and the associated Interdigit and Critical timers and Enter key parameters
• Warmline timer is enabled per subscriber, but the warmline timer value is configured per ONT and must have a lower value than the
Permanent time
• Miscellaneous timers: Permanent, Timed-release, Reanswer, Error-tone, and CW-alert timers
• Features / functions: Message waiting mode, WMWI refresh interval, DTMF volume level
• Service Codes for the following features: CW, Call Hold and Warmline
These feature items are only supported in the mesh root device or when the ONT works as a standalone device.
• Domain group/isolation
• Bridge WAN
• VLAN binding
• SoftGRE
• QoS/Rate Limit per SSID and LAN port