System Setup
3-7
Part 1604857-04
E 2014 Nordson Corporation
9
4*
6*
12
1
5
3
7
2*
2
Create Service Loop Here
Figure 3-8 Encore LT Gun Pickup Tube and Pump Installation
1. Bulkhead union
2. 6-mm black fluidizing air tubing*
3. Hose clamp
4. Blue 8-mm atomizing tubing*
5. Velcro straps
6. Black 8-mm flow-rate tubing*
7. Powder hose
9. Blue 6-mm fluidizing tubing
12. Grommet
Note: * Create service loop as noted before securing tubing to arm with straps.
WARNING: The black fluidizing air tubing (2), the pickup tube connector,
and the bulkhead union (1) are conductive and provide a ground path to the
cart. Do not replace these components with non-conductive components.
Refer to Parts for replacement tubing.
NOTE: The pump is equipped with quick-connect couplings that allow you
to quickly disconnect the air tubing when cleaning or repairing the pump.
Pull back on the knurled coupling rings to uncouple them.
To Next Page
Loading...
