Melter Communications
C-3
Part 1024496_06
2014 Nordson Corporation
To install Blue Series software
1. Do one of the following:
If you are installing using the single file installation, locate and
double‐click on the file BlueSeries.exe.
If you are installing from the span diskette set, insert Disk 1, and
then locate and double‐click on the file Setup.exe.
The Blue Series Software Setup wizard appears.
2. Click Next, and then follow the on‐screen instructions. If you are installing
from the span disk set, you will be prompted to insert additional diskettes
(2 through 5) as required by your operating system.
NOTE: When prompted to select an installation location, Nordson
Corporation recommends that you select the default location offered.
3. When the installation complete message appears, click Finished.
To Next Page
Loading...
