Installation
3-47
Part 1024496_06
2014 Nordson Corporation
Installing Optional Equipment
Each item of optional equipment is shipped with instructions for installing and
operating the equipment. Refer to Section 7, Parts, for equipment part
numbers.
Connecting a Gun Driver, Pattern Controller, or
Timer
If applicable, complete the melter installation by connecting the guns to the
desired gun driver, pattern control, or timer. Refer to the product manual
provided with the device for information about installing and operating the
equipment.
Flushing the Melter
Before using the melter for production, it should be flushed to remove any
residue left over from factory‐testing. Flushing the melter is accomplished by
processing a minimum of one tank volume of hot melt through the melter,
hoses, and guns.
Refer to Section 4, Operation, for information about filling the tank and
operating the melter.
Setting Up Melter Communications
You can transfer melter settings between melters, and upgrade or
downgrade the melters operating firmware by using a personal computer that
is connected to your melter's serial port.
Refer to Appendix C, Melter Communications, for information about
downloading, installing, and using the software that is required to connect a
personal computer to your melter.
To Next Page
Loading...
