400/480 Volt ProBlue Adhesive Melters
E-1
Part 1024496_06
2014 Nordson Corporation
Appendix E
400/480 Volt ProBlue Adhesive Melters
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
This appendix provides information about the 400/480 volt versions of the
ProBlue adhesive melter. Key information provided in this appendix, which
does not appear in the body of this manual, includes:
Installation instructions that are specific to the 400/480 volt melters
and transformers
Transformer sizing guidance
Transformer troubleshooting
Parts and service kits that are specific to the 400/480 volt melters and
transformers
For setup, operation, troubleshooting, and parts information that is common
to all ProBlue adhesive melters, refer to the appropriate section of this
manual.
To Next Page
Loading...
