Nordson ProBlue P10 - Page 5

Table of Contents
iii
Part 1024496_06
 2014 Nordson Corporation
Operation 4-1..................................................
Additional Information 4‐1........................................
More About Heated Components 4‐2..............................
Filling the Tank 4‐3..............................................
Starting the Melter 4‐4...........................................
Monitoring the Melter 4‐6........................................
Confirm that the Melter is Operating Correctly 4‐7.................
Monitor Component Temperatures 4‐8..........................
Monitor Melter Faults 4‐10......................................
How F1, F2, and F3 Faults are Handled 4‐14...................
How F4 Faults are Handled 4‐15..............................
Monitor the Level of Hot Melt in the Tank 4‐17.....................
Monitor and Adjust the Operating Air Pressure 4‐17................
Monitor the Service Interval 4‐18................................
Adjusting Component Temperatures 4‐19...........................
Entering the Melter Password 4‐24.................................
Using the Melter Function Keys 4‐25...............................
Heater Key 4‐25..............................................
Pump Key 4‐26...............................................
Setup Key 4‐26...............................................
Seven‐day Clock Key 4‐27.....................................
Standby Key 4‐28.............................................
Shutting Down the Melter 4‐29.....................................
Maintenance 5-1...............................................
Relieving System Pressure 5‐2...................................
Locking Out External Communications 5‐2.........................
Cleaning the Melter 5‐4..........................................
Replacing the Filter 5‐6..........................................
Monitoring the Life of the Filter 5‐6...........................
Cleaning the Tank 5‐8...........................................
Removing the Melter from the Sub‐base 5‐10........................
Troubleshooting 6-1............................................
400/480 Volt Melters 6‐1.........................................
Safety 6‐1......................................................
Melter Faults 6‐2...............................................
Using the Troubleshooting Flowchart 6‐4...........................
Troubleshooting Quick‐checks 6‐4..............................
Returning the Melter Setup to Factory Settings 6‐5................
Identifying Electrical Components 6‐5...........................
Diagnostic Procedures 6‐11.......................................
DP.1 Isolate a Failed Control Component 6‐11....................
DP.2 Check the Tank or Manifold RTD 6‐12.......................
Reheating the Melter During an F1 Fault 6‐13...................
Remove the Tank RTD 6‐13..................................
Remove the Manifold RTD 6‐14...............................
DP.3 Check the Operation of the Power Relay or Thermostats 6‐15..
DP.4 Check the Operation of the Tank or Manifold TRIAC 6‐16......
DP.5 Check the Resistance of the Tank and Manifold Heaters 6‐17..
ProBlue Troubleshooting Flowcharts 6‐21...........................