4.3.2 Connect
1. Return to the Current Settings tab and click CONNECT.
At this point, the status shown on the bottom left of the screen should say “Connected.” Note however, that this
status references only that the software is now connected to the COM port; it has not necessarily established
communication with the dispenser.
2. To check the connection, click GET ULTIMUS V SETTINGS.
If the values in the window update to the current dispenser settings, the connection is successful.
Appendix B — RS‑232 Protocol (continued)
Ultimus V Interactive Software (continued)
Ultimus V High Precision Fluid Dispenser
79www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
To Next Page
Loading...
