Nordson Ultimus V - Page 83

The “EFDUV Example Read Ultimus V Dispense Parameters” GUI opens. Follow the steps shown below to read
the current settings of the Ultimus V dispenser.
In this example, the software opens with the COM port configuration settings as shown. Clicking the RUN arrow
runs a set of commands that will read the settings from the dispenser and display them in the box on the right
side.
3. Click the
RUN arrow
to update the
screen.
1. Select the
COM port
associated with
the Ultimus V
dispenser.
2. Ensure
that the Serial
Configuration
settings match
the settings on
the Ultimus V
dispenser.
Current
settings read
from the
Ultimus V
dispenser
Appendix B — RS‑232 Protocol (continued)
LabVIEW Driver and Example Program (continued)
Ultimus V High Precision Fluid Dispenser
83www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.