NORME LDSCDIND PLUS - User Manual

1
OPERATING INSTRUCTIONS FOR
“LDSCD PLUS” / “LDSCDIND PLUS” / “LDSCDIND PLUS D”
INSTRUMENT SERIES
This manual contains safety information that if ignored can
endanger life or result in serious injury. They are indicated
by this icon.
Keep the instrument protected from sun and water.
Avoid water splashes.
Read Carefully !
ENGLISH Version
R14-12-18
DOWNLOAD ERMES COMMUNICATION SOFTWARE
www.ermes-server.com

Summary

LDSCD PLUS Instrument Series Operating Instructions

General Safety Guidelines

3. Mainboard Connections

5. Quick Status Check

7. Main Menu Structure

Setpoint Configuration

Setting operational points for conductivity and other output modes.

Calibration Procedures

Steps for calibrating conductivity and temperature probes for accurate measurements.

Parameter Settings

Configuring feed delay, pump priority, and default passcode.

Output Management Functions

8. Set-Point Configuration

8.1 Set-Point: Conductivity (On;Off)

8.2 Set-Point: Conductivity (Proportional)

8.2 Set-Point: Proportional Water Meter

8.3 PWM Proportional Modes

8.5 PWM Fixed Conductivity

8.5 PID Control Setup

9. Probe Calibration

9.1 Conductivity Probe Calibration

Detailed steps for zero and second point calibration of conductivity probes.

9.1 Temperature Probe Calibration

Calibrating the temperature probe using external measurement.

10. Parameter Settings

11. Output Manager

13. Dosing Alarm Configuration

15. Probe Failure Detection

18. mA Outputs Configuration

19. Out of Range Alarm Settings

24. Water Meter Setup

25. Feed Forward PID Loop

Appendix: Communication Software Setup

RS485 Communication Configuration

Appendix: TCP;IP Network Configuration

Appendix: MODBUS Communication Protocol

Appendix: Temperature Compensation

NORME LDSCDIND PLUS Specifications

General

Brand	NORME
Model	LDSCDIND PLUS
Category	Controller
Language	English