Nortel CallPilot 150 - Adding Special Characters to an External Transfer Number

Chapter 7 Working with CCR Trees 75
CallPilot 150 Telephone Administration Guide
Adding special characters to an external transfer number
Special characters are pauses or other dialing instructions that you can add if they are required to
access the network or a destination number.
Adding special characters to a destination number
Press Description
¤
or
DI G S
to resume adding digits to the destination phone number.
‹
or
PAUS
to enter a timed pause that appears as
P
on the display. Pauses are four seconds long.
You can press
PAUS
again to enter another four second pause.
›
to recognize dial tone (behind PBX). The Recognize Dial Tone special character
appears as
D
on the display.
fi
or
OTHR #
to enter a #.
fl
or
OTHR *
to enter a
*
.
OTHR
then
T
ONE
to recognize dial tone (behind PBX). The Recognize Dial Tone special character
appears as
D
on the display.
•
to cancel and retry.