Chapter 7 Working with CCR Trees 77
CallPilot 150 Telephone Administration Guide
Testing a CCR Tree
After you a build a CCR Tree and assign it to a Greeting Table, test the CCR Tree. To test the CCR
Tree, call the company number and test each node.
Check that:
• the Home node routes the call as designated
• each transfer routes the caller to the intended destination
• each prompt has correct information
• messages are courteous and easy to understand
Disabling a CCR Tree
Before you make any changes to a CCR Tree you must ensure service is not disrupted by removing
any references to the CCR Tree from the Greeting Tables and the CLID Routing Table.
To disable a Tree
1 Press ≤·°‹.
Enter the System Administrator Mailbox number and password,
and then press OK
.
2 Press AA
.
3 Press TABLE
.
4 Enter the Greeting Table number and press OK
twice.
5 Press NEXT
until the display shows:
6 Press CHNG
if you want to disable the morning CCR Tree
or
press NEXT
until the CCR Tree you want to disable is displayed.
7 Press DISABLE
.
8 This display appears briefly.
9 Press ® to end the session.
Log:
QUIT RETRY OK
Admin
MBOX AA
OTHR
Auto Atdt Admin
GRTG TABLE
LINES
Grtg table:
RETRY OK
Morning:1
CHNG PLAY NEXT
Morn CCR tree: x
CHNG NEXT
Morn CCR tree:
DISABLE
Tree disabl ed
To Next Page
Loading...
