Nortel CallPilot 150 - Changing a Mailbox Node

80 Chapter 7 Working with CCR Trees
P0919416 03
Changing a Mailbox node
To change a Mailbox node
1 Press ≤·°‹.
Enter the System Administrator Mailbox number and password,
and then press OK
.
2 Press OTHR
.
3 Press CCR
.
4 Press ADMIN
.
5 Enter the number of the CCR Tree that you want to change and press
OK
.
6 Press CHNG
.
7 Enter the Path of the node you want to change and press OK
.
8 Press CHNG
.
9 Press CHNG
.
10 Enter the new mailbox number.
Make sure the mailbox is initialized before you assign it to a CCR
Tree.
11 Press OK
if you want to accept the assigned destination type
or
press CHNG
and assign a new destination type.
12 Press END
.
13 Press SAVE
.
14 Press YES
.
15 This display appears briefly.
16 Press ® to end the session.
Log:
QUIT RETRY OK
Admin
MBOX AA OTHR
Admin
GLIST CCR
CCR Admin
ADMIN
CCR tree:
RETRY OK
Tree: x
CHNG QUIT
Path:
RETRY END OK
x LvMsg
CHNG ERASE OK
Mbox: xx
CHNG NEXT
Mbox:
DIR QUIT
Dest: <xxxx>
CHNG OK
Path:
RETRY END OK
Tree: x
SAVE PRINT QUIT
Save as tree x
YES
OTHR QUIT
Tree saved
CCR Admin
ADMIN