11
SECTION II
Time and Date
CHANGING THE TIME AND DATE SETTINGS
Use this feature to change the clocks to GMT (winter) and BFT (summer) times. Clocks in spring is
**forward and in fall is **back. In this example, the time is changed to 1:30 p.m. and the date is changed
from January 1, 2001, to July 15, 2001.
To adjust the time and date on the entire system, you need only adjust the clock at one
extension using the Basic password. The clock, which also controls the schedules for
your routing and ringing features, must be re-set after a power failure.
ACTION VISUAL DISPLAY
1. Place the programming overlay over the appropriate buttons on
your programming telephone (refer to "PROGRAMMING
OVERLAYS" on page 5).
1 Jan 1:00 am
2. Press
≤ followed by ••°›fl‹ (the Time and Date
code) followed by
¤¤‡›¤(the Basic password).
Hour: 01
NEXT CHANGE
3. Press
CHANGE
.
Hour:__
CANCL
4. Use the keypad to enter the two-digit hour. The display shows
one or two digits. The display prompts you to choose AM or PM.
AM
OK CHANGE
5. Press
CHANGE
.
AM
OK CHANGE
6. Press
OK
.
Hour:01
NEXT CHANGE
7. Press
NEXT
.
Minutes:01
NEXT CHANGE
8. Press
CHANGE
.
Minutes: __
CANCL
9. Using the keypad, enter the minutes.
Minutes:30
NEXT CHANGE
Press ® to end the session if you do not want to go on to change
the date. To change the date, continue with Step 10.
10. Press
NEXT
.
Year:01
NEXT CHANGE
11. Press
CHANGE
.
Year:___
CANCL
12. Use the keypad to enter the year.
Year:01
NEXT CHANGE
To Next Page
Loading...
Need help?
General
