10 Advanced Setup & Installation
10.1 Dual Head Mode
The projector supports Dual Head mode via video inputs DVI-1&2. In this mode of operation, the following
options are supported:
NOTE! Projector smear suppression settings are not available in this mode of operation.
10.1.1 RGB + Separate IR Input
The projector accepts an RGB video input plus an IR video input to support enhanced NVG training.
• Projector DVI-1 is the RGB input, projector DVI-2 is the IR input.
• Projector video input resolution must be 1920x1200@60 for P1 WUXGA projector model
variants and 2560x1600@60Hz for P1 WQXGA projector model variants on each input.
• Image Generator (IG) outputs must be synchronous (see illustrations Fig. 1 & Fig. 2 below for
further guidance):
Fig. 1 - Single projector synchronous input Fig. 2 - Dual projector synchronous input
NOTE! - Failure to Sync / Genlock the IG’s properly may result in on screen image artefacts or
the image not being displayed at all.
Recommended projector setup / workflow procedure is as follows:
• Select DVI-1 as Source.
• Go to the Installation menu and select WUXGA@60/WQXGA@60*¹ as Edid for both DVI-1 and
DVI-2.
• Go to Picture menu and select Dual input mode - sequential.
• Select DVI-1&2 as Source.
*¹ - P1 projector model variant native resolution dependent.
To Next Page
Loading...
