5 Safety and General Information
5.1 Safety
• This projector complies with safety regulations for Information Technology Equipment intended to
operate in a normal (office-like) environment. Please read the safety instructions before set-up and
operation.
• Use only the supplied, grounded power cord or an approved replacement power cord. Unplug the
projector if it is not used over an extended period.
• Always operate the projector within the stated voltage, humidity and temperature specifications.
OPERATION OUTSIDE THE SPECIFIED LIMITS MAY AND PROBABLY WILL DAMAGE THE UNIT!
• To reduce the risk of electrical shock and fire, do not expose the projector to moisture or rain.
• Never expose the projector to smoke, dust, sand or other fine particles, oil or chemicals.
• To avoid overheating, install the projector properly to allow for free air-flow. Observe the minimum
distance to a solid object guidance described within this User Guide. Make sure the ambient
temperature is within specified limits to reduce fan noise and ensure long life. Cool air intakes are on the
front and the on the sides to the front, while warm air is exhausted to the rear. NEVER COVER THE
VENTILATION SLOTS!
• DO NOT STARE INTO THE LIGHT BEAM! Strong light is emitted from the projection lens and staring into
the light beam may cause eye-damage.
• NEVER OPEN THE PROJECTOR! The unit contains no user-serviceable parts. Refer all service to qualified
personnel only.
5.2 Warnings
• When installing in table mount orientation make sure that the projector is positioned on a suitable flat,
correctly rated load bearing surface. When not in table mount orientation make sure that the projector
is properly fastened and secured to an approved mount using the mounting interface points provided
(underside of projector).
• Regularly clean the ventilation slots (inlet and exhaust) with a vacuum cleaner to ensure optimal cooling
and lowest fan noise is always maintained.
• Make sure no objects enter the ventilation openings of the projector.
• Remove the lens cap before turning on the projector. The lens cap may melt and damage the lens if it is
not removed before use.
• Only connect the projector to specified signal sources. Connecting to other sources may result in
distorted images and malfunction.
• Do not drop the projector.
To Next Page
Loading...
