NovaStar MX2000 Pro - Page 20

MX2000 LED Display Controller User Manual
www.novastar.tech
16
The home screen is shown in Figure 4-1 and the home screen descriptions are shown in Table 4-
1.
Table 4-1 Home screen descriptions
Area
Content
Description
Top line
MX2000 Pro
The device name.
The name can be changed in VMP software.
The device button and touchscreen lock status.

When the icon is displayed: The buttons are locked.

When the icon is not displayed: The buttons are unlocked
Hold down the knob and BACK button simultaneously for 5s
or longer to lock or unlock the buttons and screen.
The connection status of the USB drive

Green: Connected

When the icon is not displayed: Disconnected
192168102187
The device IP address
Input /
Output
IN 1 to 2
The device input source type and status.

Green: The input source is connected.

Red: The input source is being used for the screen but not
connected.

Gray: The input source is not connected.
OUT 1 to 2
The status of the output Ethernet ports.

Green: The Ethernet port is connected and working
normally.

Red: The Ethernet port is connected but working
abnormally.

Gray: Disconnected
When the Ethernet port, associated card, or associated device
is used as a backup, you will see an orange triangular icon
displayed in the top-right corner.
MVR (Reserved)
The status of the MVR card ports.
Control
CTRL
The status of the control Ethernet port, AUX port, and
GENLOCK port.