3 - 22 en-938821/2
On the PC side
Select the HARDCOPY.BMP target file.
Select the direction of transfer by the command NC -> PC.
Display of the dialogue box Download PC -> NC-PLC.
The hardcopy is downloaded by action on the Transmit key.
If the file already contains data, a message requests confirmation of overwrite of the old data.
If overwrite is accepted, the file is downloaded. Duplicate the file created by a copy/paste operation to avoid overwriting
it by the next file sent.
3.4.2 Keyboard Sound
The operator panel keyboard beeps each time a key is pressed.
This sound function can be activated or deactivated.
Actions
Activate or deactivate the keyboard sound function. ☞
CTRL
+
G
3.4.3 Switching between Operator Panels
On CNCs with two to four panels, only one panel is active at a time (at power on, it is panel 1).
A switch can be made to another panel.
To prevent a panel from being accidently deactivated from the inactive panel, the active panel can be locked by a
password.
Requirements
Active panel indicated by panel number indicator (KBD1 or KBD2) in the status window (See 3.1.3).
Actions
Locking the active panel
Lock the active panel. ☞
CTRL
+
I
Enter a password (four characters maximum). ☞
The active panel is locked and can only be deactivated by using the password.
Switching to an inactive panel
Request switchover at the inactive panel. ☞
CTRL
+
I
Enter the password (if any). ☞
The switchover is executed. The panel number indicator is displayed in the status window of the newly activated panel
and disappears from the other. The newly activated panel «beeps».
To Next Page
Loading...
Need help?
General
