CNC Operation
en-938821/2 5 - 27
5
Incidents
The loaded programme has the same number as a programme already in memory
When the loading procedure has been completed, the "INCYC" is still displayed and the following message appears:
PROG. EXISTS - OK TO OVERWRITE ? (Y/N):
Enter the letter corresponding to the desired action (Y = yes, N = no). ☞
A positive answer causes the old programme to be overwritten and the new programme to be stored.
A negative answer cancels the loaded programme.
Loading re-starts until the Xoff character is encountered at which point the "INCYC" indicator disappears and the "FILE
LOADING" menu is displayed.
The programme loaded has the same number as the programme in the protected memory.
When loading is completed, the "INCYC" indicator remains displayed and the following message appears:
"WARNING, THIS PROGRAMME EXISTS IN A PROTECTED ZONE
CREATE THE PROGRAMME IN ZONE 0? (Y/N):"
Enter the letter corresponding to the desired action (Y for yes, N for no). ☞
A positive answer causes the programme to be stored.
A negative answer cancels loading.
The "INCYC" indicator disappears and the "FILE LOADING" menu is redisplayed.
The RAM is full
The "INCYC" indicator disappears and the "FILE LOADING" menu is displayed.
The peripheral stops sending data.
Display of the error indicator (error 36) in the status window (See 3.1.3).
Acknowledge the error. ☞
The error indicator disappears.
Delete unused programmes (See 5.4.2.3) and restart the loading procedure.
No programme start character (See Programming manual)
Data is sent over the link, but not acknowledged by the CNC.
Cancel the loading procedure. ☞
The "INCYC" indicator disappears.
To Next Page
Loading...
