NUM 1050 M - QVN Axes Missing; Missing QVN Measured-Only Axes

7 - 16 en-938821/2
7.20 QVN Axes Missing
Message displayed at initialisation
ERROR: MISSING QVN DECLARED AXES
CONTINUE (Y/N)?
Comment
Speed sensor addresses declared in parameter P71 are not included in the list of servo-controlled axes declared in
parameter P3 (See Parameter Manual).
Actions
Acknowledge the message. ☞
Y
The system is available, but the machining modes are inhibited and power cannot be applied to the system.
The "PRSOV" system fault indicator is displayed in the status window (See 3.1.3).
Enter the missing axis addresses in parameter P3 (See Parameter Manual).
Reset the system to take the new parameter into account.
7.21 Missing QVN Measured-Only Axes
Message displayed at initialisation
ERROR: MISSING QVN DECLARED MEASURING
ONLY AXES
CONTINUE (Y/N)?
Comment
The addresses of axes declared as measured only by QVN (sensor declared in P70 but not in P71) are not included
in the list of measured-only axes (declared in P2 but not in P3, see Parameter Manual).
Actions
Acknowledge the message. ☞
Y
The system is available, but the machining modes are inhibited and power cannot be applied to the system.
The "PRSOV" system fault indicator is displayed in the status window (See 3.1.3).
Enter the missing axis addresses in parameter P2 (See Parameter Manual).
Reset the system to take the new parameter into account.