NUM 1050 M - No Movement in Manual Mode

6 - 6 en-938821/2
6.2 No Movement in Manual Mode
Failure symptoms
The manual controls do not generate any movement.
Trouble-shooting
Refer to the manufacturer's
manual for the
procedure to follow.
Rotate the feed
potentiometer.
Is the rate
override
potentiometer
set to zero
?
One of the axes
on its travel
limit ?
1
Yes
No
Yes
Yes
No
No
Display the message on page
"OPERATOR MESSAGES"
Is the
MSG indicator
displayed
?
Remove the axis from
the stop as per the
manufacturer's
instructions.
☞
PLC
I/O
)
0