List of Errors
en-938821/2 B - 1
B
Appendix B List of Errors
B.1 Miscellaneous Errors and Machine Errors B - 3
B.2 Parametric Programming Errors B - 4
B.3 Profile Geometry Programming (PGP) Errors B - 5
B.3.1 The end point is not determined or cannot be
computed from the elements in the blocks B - 5
B.3.2 The point of tangency or intersection
cannot be computed from the data in two
blocks B - 5
B.3.3 The points of tangency or intersection c
annot be computed from the data in three
blocks B - 5
B.3.4 Fillet or chamfer definition errors B - 5
B.3.5 Miscellaneous errors in PGP B - 6
B.4 Miscellaneous Errors B - 6
B.5 Request for Movements Outside the Machine Travel Limits B - 6
B.6 Structured Programming Errors B - 7
B.7 Axis Errors B - 7
B.8 Errors in Pocket Cycles B - 8
B.9 Axes Not Identified on the Bus B - 8
B.10 Dynamic Operators in C B - 9
B.11 Spline Curve Interpolation Errors B - 9
B.12 Errors in Numaform B - 9
B.13 Cycle Programming Errors B - 10
To Next Page
Loading...