NUM 1050 M - Not Enough Memory to Execute the Pocket Module; Wrong Number of PLC Axes

7 - 10 en-938821/2
7.8 Not Enough Memory to Execute the Pocket Module
Message displayed at initialisation
NOT ENOUGH ROOM FOR LOADING
...POCKET ALGORITHM
CONTINUE (Y/N)?
Comment
There is not enough RAM to execute the pocket module even though it is present in the configuration.
Actions
Acknowledge the message. ☞
Y
The system is available, but the pocket module cannot be executed.
Add RAM to be able to execute the pocket module.
Contact NUM customer support.
7.9 Wrong Number of PLC Axes
Message displayed at initialisation
WRONG NUMBER OF PLC AXES
CONTINUE (Y/N)?
Comment
Fewer PLC axes were declared by machine parameters than the number set by customisation.
Actions
Acknowledge the message. ☞
Y
The system is available, but the machining modes are inhibited.
The "PRSOV" system fault indicator is displayed in the status window (See 3.1.3).
Edit the parameters relative to PLC axes (See Parameter Manual).
Reset the system to take the new parameters into account.