5 - 44 en-938821/2
Mode change
The most frequent cases when the operator wishes to change the current mode are to:
- modify programme blocks (See 5.4.2.2),
- execute instructions outside the programme in manual data input mode (See 5.3).
Select another mode.
At the end of an interruptible block, the system cancels the current execution mode.
The "INCYC" indicator disappears from the status window, the newly selected mode replaces the previous mode (at
the end of a machining cycle, when manual data input, edit, tool setting or search modes are requested).
Perform the desired operations.
Return to the initial mode.
Resume execution by pressing the "CYCLE" pushbutton on the machine panel.
Feed stop using the "FEED STOP" button
Movements can be interrupted immediately using the "FEED STOP" button on the machine operator panel (See
5.5.1.1).
Programmed stop
Reading function M00 (or M01 if enabled) interrupts programme execution and requires operator intervention (See
5.5.2.1).
Forcing of recall mode
The recall mode is forced when function M12 is read during programme execution and requires operator intervention
(See 5.5.2.2).
End of programme execution
End of programme
Reading function M02 corresponds to the end of the programme.
The end of part programme indicator (M02) is displayed in the status window (See 3.1.3) and the "INCYC" indicator
disappears.
Spindle rotation stops.
Press the "CYCLE" pushbutton on the machine panel to restart programme execution from the beginning.
Reset
A reset clears all the data currently being processed (See 5.5.1.8).
To Next Page
Loading...
