5 - 78 en-938821/2
Code selection
The operator selects the character code (ISO or EIA) used to save programmes and tool dimensions.
Switch between codes. ☞
SHIFT
+
#
3
Display of the selected code at the bottom of the screen.
REMARK When the programe or tool dimensions are to be printed, only the ISO code can
be used.
Incidents
Loading in progress
If you select "PROGRAMMES", the following message is displayed:
REFUSAL: Other function in progress
Wait for the end of loading and repeat the procedure.
The "BACKGROUND UNLOAD" function cannot be accessed
Programmes cannot be unloaded in background mode except in the authorised modes (See requirements).
Display of the message:
REFUSAL: Disallowed in this mode
Exit by selecting a display page.
5.9.3.1 Unloading the Active Programme to a Peripheral
Select "ACTIVE PROGRAMME". ☞
)
0
Display of the message:
Unloading in progress
Exit with message: "<<--"
The programme is unloaded to the peripheral for backup or printing.
When the unloading procedure has been completed, the following message is displayed:
Unloading completed
Exit with message: "<<--"
The programmed has been archived.
Acknowledge the message displayed. ☞
REMARK When several programmes with different suffixes (%X.0, %X.1, %X.2, ...) corres-
pond to the number of the active programme, these programmes are archived one
after the other (without Xoff characters between).
To Next Page
Loading...
