en-938821/2 5 - 99
CNC Operation
5
Syntax
[programme] [filename].[ext]
[programme] is the name of the part programme(s):
- %[programme No.].[group No.] specifies a single programme
- %[programme No.].* specifies all the programmes with the same
number for the different axis groups
- %% specifies all the programmes in the memory
[[filename] target filename for the programme(s) to be saved
[ext] target extension for the programme(s) to be saved.
Display of the message:
unloading part programme:
[filename].[ext]
in progress...
When unloading is complete, the dialogue line is cleared.
The programme is stored.
Incidents
There is a syntax error in the file name or programme name
Display in the dialogue window of one of the following messages:
Incorrect programme start. Press any key ..
Incorrect group number. Press any key ..
Incorrect file name. Press any key ..
Incorrect file extension. Press any key ..
Acknowledge the message. ☞
Key
No programme is unloaded.
The programme does not exist.
Display in the dialogue window of the message:
Part programme does not exist. Press any key
Acknowledge the message. ☞
Key
No programme is unloaded.
End of the Procedure
Exit from the page. ☞
OUT
Exiting from the page does not interrupt loading in progress.
To Next Page
Loading...
