en-938821/2 7 - 3
System Faults
7
Faults detected during system initialisation cause the display of a message.
The table below refers to the procedure to remedy the fault depending on the message displayed:
REMARK Some procedures include operations on machine parameters; these may be
performed by the operator if he is qualified. Otherwise, they must be performed by
the OEM.
Message See
PARAMETER TABLE
7.1
CHECKSUM ERROR
CONTINUE (Y/N)?
OPTIONS NOT VALID
7.2
CONTINUE (Y/N)?
ALL S/W OPTIONS VALID
7.3
THIS SYSTEM IS NOT IN WARRANTY
CONTINUE? (Y/N)
TOO MANY AXES OR SPINDLES
7.4
CONTINUE (Y/N)?
SAMPLING PERIOD TOO SMALL !
7.5
IT MUST BE, AT LEAST, EQUAL TO
xxxx MICROSECONDS
FOR THE NUMBER OF AXIS/SPINDLES
SPECIFIED IN MACHINE SETUP DATA
DO YOU WANT TO CONTINUE ? (Y/N)
PARAMETER TABLE INDEX ERROR
7.6
RE-INIT TABLE ?(Y):
MISSING AXIS
7.7
DO YOU WANT TO CONTINUE ? (Y/N)
CONTINUE (Y/N)?
NOT ENOUGH ROOM FOR LOADING
7.8
...POCKETING ALGORITHM
CONTINUE (Y/N)?
WRONG NUMBER OF PLC AXES
7.9
CONTINUE (Y/N)?
WARNING: SAMPLING PERIOD
7.10
IS NOT A MULTIPLE OF 2 ms
CONTINUE (Y/N)?
ERROR: SENSOR DECLARED CONNECTED SEVERAL
7.11
TIMES TO THE QVN CARD
CONTINUE (Y/N)?
ERROR: QUESTIONABLE SENSOR NUMBER
7.12
CONTINUE (Y/N)?
ERROR: SENSOR DECLARED ON QVN CARD BUT
7.13
DETECTED ON AN AXIS CARD
CONTINUE (Y/N)?
ERROR: UNDECLARED SPEED SENSOR CONNECTED
7.14
TO THE QVN CARD
CONTINUE (Y/N)?
To Next Page
Loading...
