7 - 18 en-938821/2
Actions
Two cases can occur:
The assembler programme must be deleted
Accept deletion. ☞
Y
The system is available but without a PLC programme.
Load a programme in Ladder language (See Automatic Control Function
Programming Manual).
The assembler programme must be saved
Refuse deletion of the assembler programme. ☞
N
The system is available for modification of parameter P98. The PLC fault light flashes.
Reset parameter P98 (See Parameter Manual).
Reset the system to take the parameter into account.
The system restarts with the PLC programme in assembler.
To Next Page
Loading...
