139
Maintenance
document composed of several pages, the transmission will take place from the page
where the error occurred
• abandoning the transmission by deleting the corresponding command in the transmission
line (refer to paragraph Deleting a transmission on hold, page -86).
The terminal makes at most 5 automatic redials. The non-transmitted
document is automatically deleted from the memory and a transmission
report is then printed together with an error code and the cause for
transmission failure (see the communication error codes).
Communication error codes
The communication error codes appear in the logs and transmission
reports.
General codes
Code 01 - Busy or no fax answer
This code appears after 6 unsatisfactory attempts. Call later.
Code 03 - User break
A communication has been stopped by the user pressing the key.
Code 04 - Non programmed number
A number saved as a one-touch key or abbreviated number is not
valid-check it. (Example: a delayed transmission was programmed with a
one-touch key and this key has been deleted in the meantime).
Code 05 - Scanning default
An incident occurred with the scanner, for example, the sheet is jammed.
Code 06 - Printer default
An incident occurred in the printer: no paper, paper jam, opened cover...
In the reception mode, this incident appears only if the reception
parameter is switched to
WITHOUT PAPER (refer to paragraph Reception
without paper, page -44).
Code 07 - Disconnected
The link has been cut (bad line). Check the number and try again.
Code 08 - Quality
The document you sent was not well received. Contact your subscriber to
see if you need to send again.
Code 0A - No document to be polled
You tried to poll a document from a subscriber who had not prepared his
document (no deposit) or the password entered was incorrect.
To Next Page
Loading...
Need help?
Printer
