Oki B4545 MFP - Page 91

91
Operation
+ Set the required coordinates with the numeric keypad or  or
. Confirm your setting by pressing key OK.
845 OK - ADVANCED FCT / COPY / CONTRAST
+ The CONTRAST parameter is used to select the photocopy
contrast. Adjust the contrast using keys  and, then
validate the choice with the OK key.
+ You can also directly adjust the desired contrast using the
key, press this key several times until the required
adjustment is obtained without using
 845.
846 OK - ADVANCED FCT / COPY / LUMINOSITY
+ The LUMINOSITY parameter is used to make your original
document lighter or darker. Adjust the brightness required
using keys  and , then validate the choice with the OK key.
847 OK - ADVANCED FCT / COPY / BINDING
+ The BINDING parameter is used to choose the long or short
side according to the type of binding of your document. Make
your choice using keys  and , then validate the choice with
the OK key.
Caution - All settings made using this menu become default
settings of the terminal.
85 OK - ADVANCED FCT / SCAN. & PRINT
+ Use keys  or  of the browser to scroll the setting described
below that you want to modify.
+ Validate your setting by pressing the OK key.
851 OK - ADVANCED FCT / SCAN. & PRINT / PAPER
+ Select NORMAL or THICK paper using keys and.
+ Validate your setting by pressing the OK key.
Remark : 1) When THICK paper type is selected, the print speed is slowed down.
2) Use the manual feeder for paper with a weight greater than 24 lb.
(90 g/m
2)
.
852 OK - ADVANCED FCT / SCAN. & PRINT / PAPER
TRAY
+ Select the paper tray that you want to use; AUTOMATIC,
LOWER or UPPER using keys and .
+ Validate by pressing the OK key.
853 OK - ADVANCED FCT / SCAN. & PRINT / PAPER