28 > INSTALLATION AND RELOCATION PROCEDURE
INSTALLING A NETWORK SOFTWARE KIT
You can install a network software kit option on this printer. Installing this
option may initialize the settings of [Network/Port] and [Allocate
Memory].
1. Refer to “Preparing the printer” on page 26.
2. Hold the network software kit so its notch (1) is aligned with the
protrusion on the slot.
3. Release the hook on the top of the slot.
4. Gently insert the network software kit into the slot, and press
firmly at the top corner of the card then at the bottom corner.
CAUTION!
Never touch the connectors of the network software kit.
Never allow the network software kit to be bent or damaged.
Before handling the network software kit, touch something metal in order
to discharge any electrostatic charge built up in your body.
To Next Page
Loading...
