ERROR MESSAGES > 61
ERROR MESSAGES
If an error message is displayed at the control panel, follow the
instructions to fix the error. Depending on the message content, follow the
instructions in the Reference column below to fix the error.
The following section explains the contents and actions required for the
more complex messages. For details on messages not described here, refer
to the Reference Guide.
Message content Reference
An error code xxx-xxx is
displayed.
Refer to the Reference guide for a list of error codes.
Paper jam or “Remove paper”
is displayed.
Refer to “If paper jams” on page 56.
Installing and replacing the
drum-toner cartridge
Refer to procedures described on the consumables packaging
box or “Installing the Drum-Toner Cartridge” on page 35.
Loading and replenishing
paper
Refer to “Loading paper” on page 40.
Message Condition/Reason/Action
Corrupt HDD File.
Press SEL key
When the hard disk (option) is installed, the printer assumes that data
in the hard disk is corrupted if power is cut off when the printer is in
use.
Press the <FEED/SELECT> button on the control panel. The hard disk
will be initialized.
Initializing the hard disk will delete data for registered forms, logos,
secure print, and PostScript download fonts.
Corrupt Log file
Press SEL key
When the hard disk (option) is installed, the printer assumes that data
in the hard disk is corrupted if power is cut off when the printer is in
use.
Press the <FEED/SELECT> button on the control panel. The log file
will be initialized.
It can take 1 minute to initialize the log file. Do not switch off the
power of this printer when initialisation is in progress.
Incorrect paper
type Reselect
SEL to print
CANCEL to cancel
Paper of the type specified under [Paper Type] in the printer driver is
not loaded in the trays. Press the <FEED/SELECT> button on the
control panel to print on paper of another type or press <CANCEL> to
cancel the job.
To Next Page
Loading...
Need help?
General
