INSTALLATION AND RELOCATION PROCEDURE > 39
CONNECTING THE POWER CORD
When connecting the power cord, take heed of the information given in
“Safety precautions” on page 9.
1. Ensure that the
printer power switch
is in the <¡>
position.
2. Connect the power
cord to the power
cord connector at the
back of the printer.
Connect the other
end of the power
cord to the power
outlet.
3. Press the power
switch of the printer
to the < > position.
The power will be
applied and the
control panel will
display that the
printer is ready to
print.
NOTE
> If “Found New Hardware” displays on your screen, click Cancel.
> Depending on the network environment used, it may take some minutes
before the printer is ready for printing.
> If the message that the printer is ready to print but is unable to retrieve
an IP Address is displayed, continue operating as normal.
To Next Page
Loading...
