FCC STATEMENT > 3
FCC STATEMENT
Federal Communications Commission Radio Frequency Interference
Statement for 120-Volt Models.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Plug the unit into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio television
technician for help.
It is the responsibility of the user to obtain the required shielded cable in
order to ensure compliance of this equipment with FCC regulations.
Changes or modifications not expressly approved by Oki Data may void
your authority to operate this equipment.
Industry Canada (IC) Radio Interference Statements For 120-Volt Models
This Oki Data apparatus complies with the Class B limits for radio
interference as specified in the IC Radio Interference Regulations.
To Next Page
Loading...
Need help?
General
