INSTALLATION AND RELOCATION PROCEDURE > 41
3. Squeeze the length guide and slide it to the desired paper size (1).
Squeeze the right width guide and slide it to the desired paper size
(2).
4. Load the paper with the side to be printed facing up and with all
four corners aligned.
CAUTION!
Do not place paper over the right width guide.
Do not load paper exceeding the maximum fill line or the maximum
capacity allowed.
Align the right width guide with the paper width correctly. If the right width
guide is not in place, the paper will not be properly fed and this may cause
paper jams.
To Next Page
Loading...
