Configuring the network settings > 19
10. In the security settings screen, select the same security setting as the wireless AP
that you want to connect to.
11. Depending on the security setting selected in step 8, execute the settings from
either (1) or (2) below. If Disable is selected, proceed to step 10. (For security
reasons, we do not recommend setting Disable.)
(1) When WEP is selected:
a) Press the on the WEP KEY input screen.
MEMO
> The default is Disable.
> Depending on the model of wireless AP, mixed WPA-PSK/WPA2-PSK may be
supported. In this case, we recommend using WPA2-PSK.
NOTE
Security settings (WPA-EAP/WPA2-EAP) using an authentication server are
also supported, but this can only be set from the Web. For details, see the
Advanced section of the User Manual.
MEMO
Nothing is set by default. If the WEP KEY is already set, it is displayed using
"*" symbols. When the OK button is pressed, the screen switches to the
screen in step 10 without switching to the screen in step b). If the right button
is pressed to switch to the screen in step b) when a WEP KEY is set, the set
KEY is cleared.
To Next Page
Loading...
Need help?
General
