Chapter 14: Epson - Standard Function
14-42
For this command, Hn = 0 and Ln = 3 must be set. With Ln + Hn *
256 < 3, this command is ignored. With Ln + Hn * 256 > 3, all Ln +
Hn * 256 -3 data following Lp, Hp are ignored.
The parameters Pn
2
and Pn
3
determine the code pages which are to
be assigned to the parameter Pn
1
. The following values are permis-
sible:
Pn
1
: 00H, 01H, 02H, 03H, 30H, 31H, 32H, 33H
Pn
2
: 00H, 01H, 03H, 07H, 08H, 09H
Pn
3
: 00H
The assignment of the parameters Pn
2
and Pn
3
to the selectable code
pages is listed in the following table:
Pn
2
Pn
3
Code page
0 0 italic character set
1 0 PC437 (USA)
3 0 PC850 (Multilingual)
7 0 PC860 (Portugal)
8 0 PC863 (Canadian French)
9 0 PC865 (Norwegian)
If invalid values are assigned to the parameters Pn
1
,
Pn
2
and Pn
3
, the
previous assignment remains valid.
To each valid value of Pn
1
can be assigned one of the code pages
listed in the above table. The selection of the code pages assigned
to parameter Pn
1
is performed with the command ESC t Pn, where-
by the parameters Pn
1
and
Pn
2
must correspond.
In the initial setting after switching on or resetting the printer, the
following assignments are valid:
To Next Page
Loading...
