Chapter 1: Assembling and setting up
1-7
Removing the paper
support
The paper separator is fitted
to the printer at the factory.
The paper support must be removed to fit accessories such as the
cut sheet feeder or roll paper stand.
1. Move the paper support into
the horizontal home posi-
tion.
2. Press the paper support
downwards at the back. This
will disengage it from its
catching arrangement.
The paper support must be re-
fitted after removing the acces-
sory.
The paper separator
The paper separator prevents paper being drawn back into the
printer once it has been printed.
The paper separator has to be removed when you are using a trac-
tor feed or cut sheet feeder (accessory). If the printer is to be used
without either of these accessories, the separator must be replaced.
Caution!
The print head moves and can cause injury to the hands.
Switch the printer OFF LINE and wait until the print head stops
moving.
To Next Page
Loading...
