Chapter 3: Paper handling
3-16
Changing the tear-
off position
Do not forward paper to the
tear-off position by using the
platen knob.
With the »Form Tear-Off« function activated, you can check and set
the top of form by pressing the TEAR button in OFF LINE mode;
the paper is drawn back to the top of form. Reset the top of form by
pressing the Micro Feed Up/Down buttons with the SHIFT button
pressed. The paper is transported to the tear-off position after mak-
ing this setting.
Should you wish to change the setting of the tear-off position,
switch the printer OFF LINE with the Form Tear-Off function acti-
vated. Make sure the paper is at the tear-off position. Change the
tear-off position by pressing the Micro Feed Up/Down buttons with
the SHIFT button pressed.
When using graphics programmes, there may due to the amount of
processing to be performed by the computer be pauses in the send-
ing of data which cause the paper to be fed to the tear-off position.
The unnecessary transporting of the paper can impair accurate
registration of the graphics. In this situation, switch off the »Form
Tear-Off« function.
Checking the top of
form
To Next Page
Loading...
